| View previous topic :: View next topic
:: View posts since last visit |
| Author |
Message |
Wills4th
Joined: 17 Sep 2003
Posts: 42
Location: USA VA Waynesboro
|
 Posted: Wed Sep 17, 2003 9:40 am Post subject: Nose Fittings - "Jet Kite" |
 |
|
I have some stacked diamond kites by "Jet Kite" in Oregon. I would like to get more of the nose pieces to make and add kites to the stack. What are the legal implications of copying this 
_________________
Good Winds to Ya <>~~~~~
Will
Waynesboro, VA USA |
|
| Back to top |
|
Steve D
Joined: 02 Sep 2003
Posts: 805
Location: USA GA Newnan
|
| Posted: Wed Sep 17, 2003 10:12 am Post subject: |
|
|
Someone correct me if I'm wrong but I don't see copying a kite to use for your own purposes as a problem. Even if its design is patented or copyrighted. However, copying it to sell may be a different story - particularly if its patented or copyrighted.
Last edited by Steve D on Wed Sep 17, 2003 11:49 am; edited 1 time in total |
|
| Back to top |
|
stevef
Administrator
Joined: 27 Aug 2003
Posts: 1408
Location: USA PA ALLENTOWN
|
| Posted: Wed Sep 17, 2003 11:48 am Post subject: |
|
|
The nose fittings are hard to get ... can you describe it? Diameter of the spars used? Is the Leading Edge and Spine in the same 'plane' or is there a compound angle built into the fitting? I ask this because I have seen several types... and I am not familiar with the Jet Kite.
As far as copying a kite that is no longer in production, for your own use, I dont really see a problem. But why not change something to make it different? Or better yet, make it better!
The subject of "copying kites" comes up often and I'll be moving these posts to the "kite building" category
_________________
Steve Ferrel
Measure once, buy twice! 
|
|
| Back to top |
|
Wills4th
Joined: 17 Sep 2003
Posts: 42
Location: USA VA Waynesboro
|
| Posted: Wed Sep 17, 2003 12:33 pm Post subject: |
|
|
I would probably have you make the fitting Steve, but I don't want to ask you to do something that is illegal.
The "nose Piece" connects the two wing spars and the spine. With the kite laying on it's back the wings spars are about 90 degrees to each other and the spine sticks up at an angle. When I get ready I could send one of the pieces if that would be easiest. Then we could discuss improvements.
Thanks,
_________________
Good Winds to Ya <>~~~~~
Will
Waynesboro, VA USA |
|
| Back to top |
|
stevef
Administrator
Joined: 27 Aug 2003
Posts: 1408
Location: USA PA ALLENTOWN
|
| Posted: Wed Sep 17, 2003 12:45 pm Post subject: |
|
|
Sounds like the old Dyna-Kite nose fitting.... which would have been my first guess. There are many Dyna-Kite Knock offs out there. I have these fittings. All three holes accomodate a 1/4" OD spar.
I'll add a photo later today...
_________________
Steve Ferrel
Measure once, buy twice!
|
|
| Back to top |
|
stevef
Administrator
Joined: 27 Aug 2003
Posts: 1408
Location: USA PA ALLENTOWN
|
|
| Back to top |
|
|
Kite Studio
Catalog
Techsheets
Photo
Album
