Kitebuilder.com

woodpekr · Posted: Fri Jul 02, 2004 1:33 pm Post subject: Butane (cordless) Soldering Iron

Bought a Weller P2KC butane soldering iron a while back. I love the fact that it's cordless and the heat is variable. The self ignitor works first try every time and it heats up quickly.

There are various tips available.

I've recently cut some webbing with the Hot Knife tip and I was very pleased with the results.

I haven't cut out a kite with it yet, but I did a few test cuts on some Ripstop nylon scraps and it looked good.
_________________
Rich Durant
Portland, Oregon

Doug LaRock · Posted: Sat Jul 03, 2004 12:01 am Post subject:

Rich
I have Weller very similar and I really like it . It's cut LOTS of fabric. Iv'e just about worn out the Hot Knife tip. Glad to see others are avalable. The place I bought it said they could only get them in packs of 5. Well have fun ,cut out lots of kites.

Doug

Kitesquid · Posted: Tue Jul 06, 2004 8:31 am Post subject:

I found one at Harbor Freight but cannot find it at thier web site right now..

It looks like this one at Zztools but cost less (I think):

I have not used it yet, but I bought two, incse one gets dirty....
_________________
VR/
KiteSquid
AKA TakoIka
AKA Harold
King George VA

P.S. Yet another post by the Squid..... Shocked

Doesent he ever shut up???

P.P.S. The wind is like the air, only pushier.

Stan · Joined: 18 Nov 2003 Posts: 545 Location: San Diego

KC,
You only bought two?
You on a budget these days? Shocked

Stan

Kitesquid · Posted: Tue Jul 06, 2004 12:31 pm Post subject:

Nope,

But I did spend over $100 at Harbor Freight on that trip..... Shocked

_________________
VR/
KiteSquid
AKA TakoIka
AKA Harold
King George VA

P.S. Yet another post by the Squid..... Shocked

Doesent he ever shut up???

P.P.S. The wind is like the air, only pushier.